INSTALLATION GUIDEREAR VISION SYSTEMAEV30229ADLast Updated: 06/17/14
8vI. camera calibration for navigation unit1. Insert key into ignition, and very slowly turn two clicks forward. This will turn on the dash without
PLEASE READ BEFORE YOU STARTTO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING ANY WORK. THESE I
1FACTORY CHMSLCONNECTORAEV HARNESS AAEV CAMERA/CHMSLAEV HARNESS BRADIO HEAD UNIT12 V OUTLET(cigarette lighter ‘07-’12)FACTORY HARNESSUNPLUGGED FROM 12
2NOTE: The AEV Rear Vision System was designed to work best with AEV Wheels. If you have stock wheels, or any other wheel NOT manufactured by AEV, you
38. Peel back the carpet along the passenger side of the vehicle.9. Remove the glove compartment.10. Remove the transfer case shift lever knob by p
4II. routing the wiring harness1. Route the camera wiring harness A (see diagram pg 1) through the tailgate (g. 6) following the fac-tory wiring th
54. Connect the white plug into the back of the radio (g. 8) then reinstall the radio.Figure 85. Install the 6-pin connector onto the end of Harne
64. For vehicles without factory map lights in the mirror: Locate the white wire with the grey stripe in the wiring harness running under the front p
79. Plug connector into back of Display Mirror (g. 14) and mount to windshield.10. Reinstall all trim.Figure 14V. Installing camera to tire carrie
Komentáře k této Příručce